Craftsman 7174827 Operation Manual - Page 8

2 Remove the vacuum tube assembly., 3 Remove the debris from impeller Mades.. 4 Check the impeller for any signs of damager If it is damaged, contact your Sear Service Center (refer to the back cover). 5_ Install the vacuum tube or, if you want to switch to blower mode, the bottom inlet cover, Refer to Converting from Blower to Vacuum or Converting from Vacuum to Blower for more information. Store the blowedvacuum and extension cord indoors, in a cool dry location, out of reach of children and animals.. Problem Appliance does not operate., Appliance vibrates abnormally, makes an abnormal noise, or the impeller does not turn freely Possible Cause t Switch is in the Off position.. 2 The inlet cover or vac tube is not locked in place.. 3. The power cord is disconnected, 4.. Mechanical failure 1. Debris is caught in the impeller 2, Mechanical failure Corrective Action 1,, Turn the switch to On, 2., Ensure that the bottom inlet cover or vacuum tube is locked in place, 3, Ensure that the extension cord is fully connected to the blower and the power supply, 4, Contact Sears Service (see back cover), Turn off the appliance, disconnect the power supply and, remove the debris from the impeller (refer to Removing Clogged Debris from the Impeller) 2 Contact Sears Service (see back cover),.