Craftsman 79653 Instruction Manual - Page 7

the spring in the shaft are firmly seated into shaft housing. Do not attempt to insert shaft into shaft housing without fully extending and securing shaft as outlined in #1 above. depths and 1 transportation mode. To adjust the depth of the cut, move the front adjustment lever up or down to the desired depth setting. Cutting depths are 518", 1" and 1 1/2". (see depth indicator label). 4. Front Handle Assembly = Line up front handle as shown in Figure 3, then push handle onto upper assembly so the holes line up. Secure the shaft with the screw and plastic knob. TRANSPORT MODE The edger can be raised for transportation and storage. To adjust to transport mode, lower the lever to the bottom "Roll" position. The "Roll" position raises the edge guide so that it does not hit the ground while transporting. EDGE GUIDE The EZ-Edge-n-Store is equipped with a fixed edge guide that makes it easy to follow a sidewalk or curb. ATTACHING EXTENSION CORD You can securely fasten the extension cord by tying it in a knot with the pigtail cord as shown in Figure 4. CAUTION - Make sure the edger blade wilt only contact dirt before turning on. \\ \ REMOVING THE BLADE COVER Fj_ure-4 EDGING DEPTH DANGER - Never attempt to adjust the depth while the edger is running. The EZ-Edge-n-Store can be adjusted to edge at different depths - 3 edging The blade cover can be easily removed to clean out dirt and debris. Depress the button on the top of the blade cover and lift up to remove the blade cover. To re-attach the blade cover, simply line up blade cover over the blade guard and press down until the button locks in place. For your safety the edger will not operate unless the guard is locked securely in place. See Figure 5. 7