Craftsman 79653 Instruction Manual - Page 8

adjustetdo anuprighsttoragpeosition byliftinguptheredlockatthebase oftheshaftandmovintgheshaft forwardin, totheuprighptositionT.he redlockringwillsnapfirmlyintoplace intheuprighptositionS.eeFigure7. TURNING THE EZ=Edge=n=Store ON Once the unit is plugged in and you are ready to start edging, simply push the unit's safety trigger in with your thumb while pulling up on the trigger (under the handle) with your fingers. See Figure 6. The thumb safety switch is only for starting the unit and can be released during edging. To turn off the unit, release the trigger and the safety switch wilt snap out to prevent the trigger switch from being accidentally depressed. Fi=_ure-7 EDGING INSTRUCTIONS TECHNIQUES AND * Always keep the extension-cord away from the area being edged. Make sure the extension cord is behind the edger. If you cut or damage the cord, unplug it immediately. AFTER the cord is unplugged, inspect it for damage and repair or replace it if necessary. * Maintain proper balance at all times. Keep hands away from blades. Wear eye protection when using the unit. Hold the trimmer firmly with both hands and turn ON. * Do not use the edger with wet growth or in the rain. STORAGE POSITION CAUTION: If the edger becomes jammed or stalled on a branch, sticks, or foreign object, release the trigger immediately. Failure to stop the unit when the unit jams may cause excessive damage to the unit's motor. The Edge-n-Store Edger shaft can be 8