Cub Cadet 2X 30 inch MAX Operation Manual - Page 28
Cub Cadet 2X 30 inch MAX Manual
View all Cub Cadet 2X 30 inch MAX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
SERVICE AND MAINTENANCE 7. Remove belt from around auger pulley, and slip it between support bracket and auger pulley (Figure 85). Figure 85 NOTE: Engaging auger control will ease removal and reinstallation of belt. 8. Replace auger belt by following instructions in reverse order. NOTE: Make sure to reinstall shoulder bolt (a) and reconnect spring to frame after installing a replacement auger belt (Figure 84). 9. After replacing auger belt, perform Auger Control test in Assembly & Set-Up section (page 17). DRIVE BELT REPLACEMENT NOTE: See your authorized service dealer to have drive belt replaced or contact Customer Support. FRICTION WHEEL INSPECTION (STEERABLE 500 AND 800 SERIES & NON-STEERABLE SINGLE SPEED 600 SERIES) If snow blower fails to drive with drive control lever engaged, and performing drive control cable adjustment fails to correct problem, the friction wheel may need to be replaced. IMPORTANT: Special tools are required and several components must be removed in order to replace the friction wheel rubber. See your authorized service dealer to have friction wheel rubber replaced or contact Customer Support. To inspect friction wheel, proceed as follows: 1. Allow engine to run until it is out of fuel. Do not attempt to drain fuel from engine. Remove safety key or disconnect spark plug wire. 2. Carefully pivot snow blower up and forward so that it rests on auger housing. 3. Remove frame cover from underside by removing four selftapping screws (Figure 78). 4. Inspect friction wheel for signs of wear or cracking. 5. Using the four self tapping screws, reinstall the frame cover (Figure 78). 6. If friction wheel rubber must be replaced see your authorized service dealer to have friction wheel rubber replaced or contact Customer Support. FRICTION WHEEL REMOVAL (MULTI-SPEED NON-STEERABLE 600 SERIES) If snow blower fails to drive with drive control lever engaged, and performing drive control cable adjustment fails to correct the problem, friction wheel may need to be replaced. Follow the instructions below. Examine friction wheel for signs of wear or cracking and replace if necessary. 1. Allow engine to run until it is out of fuel. Do not attempt to drain fuel from engine. Remove safety key or disconnect spark plug wire. 2. Place shift lever in first Forward (F1) position. 3. Carefully pivot snow blower up and forward so that it rests on auger housing. 4. Remove frame cover from underside by removing selftapping screws (Figure 78). Remove right-hand wheel by removing screw and bell washer which secure it to axle. See (Figure 86). Figure 86 5. Carefully remove hex nut (a) which secures hex shaft to frame and lightly tap the shaft's end to dislodge ball bearing from right side of frame (Figure 87). Ball Bearing a Figure 87 NOTE: Be careful not to damage threads on shaft. 28