Cub Cadet RZT S 46 RZT S 42 Operator's Manual - Page 14
PTO Knob, Fuel Tank Cap, Hour Meter/Indicator Panel, Throttle/Choke Control - blades
View all Cub Cadet RZT S 46 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
PTO Knob The PTO (Power Take-Off) knob is located on the RH console to the right of the operator's seat. The PTO knob operates the electric PTO clutch mounted on the bottom of the engine crankshaft. Pull the knob upward to engage the PTO clutch, or push the knob downward to disengage the clutch. The PTO knob must be in the "disengaged" position when starting the engine. Fuel Tank Cap The fuel tank cap is located on the left console. Turn the fill cap to remove. Always re-install the fuel cap tightly onto the fuel tank after removing. WARNING! Never fill the fuel tank when the engine is running. If the engine is hot from recently running, allow to cool for several minutes before refueling. Highly flammable gasoline could splash onto the engine and cause a fire. Hour Meter/Indicator Panel The hour meter/indicator panel is located on the RH console to the right of the operator's seat. Hour Meter Features The hour meter records the hours that the tractor has been operated in the digital display (tenths of an hour - right most digit). BATT. OIL HOURS 1/10 PTO / BLADE PARK BRAKE NOTE: The hour meter is activated whenever the ignition switch is turned to the RUN position. Keep a record of the actual hours of operation to assure all maintenance procedures are completed according to the instructions in this manual and the engine manual. When key is turned to the RUN position, the battery indicator light briefly illuminates and the battery voltage is briefly displayed. The display then changes to the accumulated hours. The Indicator Monitor will also remind the operator of maintenance intervals for changing the engine oil. The LCD will alternately flash, "CHG" ; "OIL" and the recorded hours for five minutes after every 50 hours of recorded operation. The maintenance interval lasts for two hours (from 50-52, 100-102, 150-152, etc.). The LCD will flash as described for five minutes every time the tractor's engine is started during this maintenance interval. Follow the oil change intervals provided in the engine manual. Indicator Panel Features Battery Indicator Illuminates and the battery voltage is displayed briefly when the ignition switch is turned to the RUN position. Illuminates to indicate the battery voltage has dropped below 11.5 (+0.5/-1.0) volts. The battery voltage is also displayed on the hour meter. If this indicator and display come on during operation, check the battery and charging system for possible causes and/or contact your Cub Cadet dealer. Oil Pressure Indicator (If Engine So Equipped) This warning lamp indicates low engine oil pressure. If the indicator comes on while the engine is running, stop the engine immediately and check for possible causes. Do not run the engine while this indicator is illuminated. Contact your Cub Cadet dealer to have the tractor and engine inspected. NOTE: The oil pressure indicator may illuminate when the ignition switch is in the RUN position, but should turn off when the engine is started. PTO Engaged Indicator This indicator illuminates when the PTO is engaged and the ignition switch is turned to the START position. Check this indicator if the engine will not crank with the ignition switch in the START position. If necessary, disengage the PTO. Parking Brake Engaged Indicator This indicator illuminates when the parking brake is in the DISENGAGED position and the ignition switch is turned to the START position. Check this indicator if the engine will not crank with the ignition switch in the START position. If necessary, engage the parking brake. Throttle/Choke Control The throttle/choke control is located on the RH console to the right of the operator's seat. When set in a given position, a uniform engine speed will be maintained. • Push the throttle/choke control lever forward to increase the engine speed. The tractor is designed to operate with the throttle/choke control in the FAST position when the tractor is being driven and the mower deck is engaged. • Pull the throttle/choke control lever rearward to decrease the engine speed. • When starting the engine, push the control lever fully forward into the CHOKE position. • After starting and warming the engine, move the control lever rearward until you feel it move past the choke detent. CHOK E FAST SL OW 14 Section 4- Controls & Features