Cub Cadet RZT SX 42 Operation Manual - Page 7
Operation - problems
View all Cub Cadet RZT SX 42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Operation 5 Pre-Operation Check The engine is shipped without gasoline and with oil in the engine. See the Set-Up Section of this manual for instructions on adding gasoline and checking oil. Starting Engine Rotary Key Switch Start 1. Place the PTO in the DISENGAGED (OFF) position. 2. Fully engage the tractor's brake. 3. Move the throttle into the FAST position. 4. Insert the key into the ignition switch. 5. Turn the ignition key clockwise to the START position and allow engine to crank up to five seconds of each crank trial until started. After the engine starts, release the key. It will return to the RUN position. See Figure 5-1. CAUTION Do NOT hold the key in the START position for longer than five seconds at a time. Doing so may cause damage to your engine's electric starter. Stop Position Run Position Start Position Push Button Start/Stop 6. Place the PTO in the DISENGAGED (OFF) position. 7. Fully engage the tractor's brake. 8. Move the throttle into the FAST position. 9. Insert the ignition key and and depress for 1.5 seconds. If the engine does not start after 5 seconds, a 3 second delay will occur. Release the key and press again to attempt to start. NOTE: If the REVERSE CAUTION MODE button is depressed during starting, the starting sequence is aborted and needs to be restarted. NOTE: When operating the tractor be certain that the throttle lever is always in the FAST position. Operating with the throttle at less than full throttle may lead to shortened battery life. INSERT KEY AND PUSH START / STOP BUTTON (HOUR METER AND LIGHTS COME ON) TO START: DEPRESS BRAKE, PUSH& HOLD START/STOP BUTTON FOR 1.5 SEC. REVERSE CAUTION MODE TO OPERATE IN REVERSE WITH BLADES ENGAGED: PUSH & HOLD ORANGE BUTTON FOR 3 SEC. LIGHT WILL FLASH THENSTAY ON TO TURN OFF : PRESS HOURS TO STOP ENGINE: PUSH START/STOP BUTTO N Stopping Engine WARNING! If you strike a foreign object, stop the engine and disconnect the spark plug wire(s). Thoroughly inspect the machine for any damage. Repair the damage before restarting and operating. 1. If the blades are ENGAGED (ON), place the PTO in the DISENGAGED (OFF) position. 2. Place the throttle near the SLOW position. 3. Engage the parking brake. • Turn Key Start: Turn the ignition key counterclockwise to the STOP position. • Push Button Start: Press or remove the ignition key. Malfunction Indicator Light A Malfunction Indicator Light will illuminate if problems or faults are detected. See engine service manual or contact authorized service dealer for details. For push button start units, the Malfunction Indicator will show as "Engine ----" and then show a code number. See engine service manual or contact authorized service dealer for details. NOTE: Removing the key will reduce the possibility of unauthorized starting of the engine while equipment is not in use. Figure 5-5 Figure 5-4 7