Cub Cadet Z-Force SX 60 Operation Manual - Page 9

Assembly & Set-Up 3 NOTE: This Operator's Manual covers several models. Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. NOTE: All references in this manual to the left or right side and front or back of the tractor are from the operating position only. Exceptions, if any, will be specified. Tractor Preparation Manually Moving the Tractor 1. Engage the transmission bypass rods, one on each side of the tractor, to move the tractor manually without starting it. The transmission bypass rods are located on the rear of the tractor, just inside each rear wheel. Engage the bypass rods by pulling each one out (a) and to the right (b) to lock it into place. See Figure 3-1. Steering Wheel Column The steering wheel column is tilted all the way back for shipping purposes. To tilt the column forward, rotate the steering column adjustment lever counterclockwise, place the column in the desired position and then rotate the lever clockwise to secure the column in place. See Figure 3-2. a b Steering Column Adjustment Lever Figure 3-2 NOTE: Be sure that the steering column adjustment lever is tight to prevent the column from moving when operating the machine. Figure 3-1 2. Disengage the bypass rods by reversing steps a & b after moving the tractor. See Figure 3-1. 3. Remove the deck wash system nozzle adapter from the manual bag and store for future use. 9