Cuisinart CAP-1000 User Manual - Page 5

INSTALLING YOUR REPLACEMENT FILTER SYSTEM 1. Your air purifier will automatically tell you when its time to change your filter. An icon on the control panel will illuminate after 2500 hours of purification has been reached. 2 . Place the 4-sided combination H13 HEPA/Active Carbon filter on a sturdy flat surface. 3. Slide the removable, reusable metal pre-filter that you have washed and dried into the slots on all 4 sides of the replacement H13 HEPA/Active Carbon filter. 4.Slide the new 4-sided filter system into the back of the unit until you feel resistance. 5. Make sure your air purifier is plugged in and powered up. YOU WILL NOW NEED TO RESET THE FILTER INDICATOR. 6. Reset the filter indicator light by pressing and holding down the night light button for 3 seconds. This will reset the filter indicator light. MAINTENANCE AND REPLACEMENT OF FILTERS AND UV-C LIGHT The H13 high-grade HEPA filters could be vacuumed as needed in order for the air purifier to perform at its best. If the air purifier contains dust or pet dander, it's best to clean the removable, reusable metal pre-filters more often than once a month to maintain 2,500 hours of filter life. Always unplug your air purifier from the electrical outlet before replacing or removing any filters or replacing the UV-C bulb. Step 1. Filter Cover Panel: The Purxium Air Purifier takes in and purifies air on all 4 sides. To remove filters contained in the unit, you will remove the filter cover panel located in the back of the air purifier. Press the button located on top of the panel to release it from the base of the unit. Step 2. Pre-Filters and HEPA H13 Filtration Set: You will now see the pre-filter and HEPA H13 and active carbon filters that you will remove from the unit by placing your fingers on the left and right side of the filter and pulling straight out. The filters are a complete set. The pre-filters may be removed by pulling them up through the slots. Step 3. UV-C Light: Follow Steps 1 and 2 for removing filters. At the base of the unit, there is one screw that hold the cover to the UV-C bulb compartment. Remove the screw with a screwdriver and carefully remove the UV-C light bulb. Replace with new a UV-C light bulb. The UV-C light bulb should be replaced at 10,000 hours of use. Contact Cuisinart customer service for your replacement UV-C light tube. WARNING: Skin or eye damage may result from directly viewing the light produced from this lamp in this apparatus. Always disconnect before relamping or servicing. Replace lamp with Lamp Model No.: Z138, manufactured by Zhangzhou Yingguang Electronic Technology Co., Ltd. FEATURES AND SPECIFICATIONS Note: The UV-C light contains mercury, which is a hazardous material. Please use gloves when removing the bulb, place into a plastic bag and drop off at a recycle facility near you. Our H13 High Grade HEPA filter captures up to 99.9% of airborne particles 0.1 Micron or larger including bacteria and various contaminants as well as dust, pollen and odors from cooking, smoke, pets and VOC's. The CAP-1000 quiet DC motor has a 3-stage filtration system that purifies air in an up to 1,000-sq. ft. area two times every hour or 500-sq. ft. area four times every hour. 5