Cuisinart CFA-10 User Manual - Page 4
Assembly Instructions, Cleaning, Storage, And Maintenance, Operating And Safety Tips
View all Cuisinart CFA-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLY INSTRUCTIONS BEFORE FIRST USE Before using your Cuisinart® continuous feed attachment for the first time, wash the work bowl, stem adapter, and slinger disc (see cleaning instructions at right). 1. Place the food processor housing base on a dry, level countertop with the controls facing you. Do not plug the unit in until it is fully assembled. 2. Substitute the food processor work bowl for the continuous feed attachment. Place the continuous feed work bowl on top of food processor base, with the work bowl handle just to the right of center. Turn the work bowl clockwise to lock it onto the housing base. CONTINUOUS FEED ATTACHMENT OPERATION 1. With the continuous feed work bowl locked into place on the food processor housing base, insert the stem adapter into the continuous feed work bowl. 2. H old slinger disc with rib facing up. Slide slinger disc over the stem adapter until it is firmly in place. 3. C arefully place slicing/shredding disc over the stem adapter with the side being used facing up. 4. P lace the food processor work bowl cover, with feed tube at the back of the work bowl, on the work bowl by latching the back on first and then pushing down on the front to lock into place. 5. P lug the food processor base into an electrical outlet. 6. Place a receptacle for processed food on counter under chute. You can use bowls or saucepans. Those with straight sides under 6 inches tall work best. 7. P ut food in feed tube. Remember to cut one end of food flat if you are slicing, and to insert in feed tube flat side down. Insert pusher and using light pressure, guide the food with one hand, while using either high, low, or pulse mode. Slinger disc will direct food through chute into receptacle. Total amount of food you can slice or shred is limited only by size of receptacle under chute. You can replace full receptacle with an empty one and continue slicing or shredding. CLEANING, STORAGE, AND MAINTENANCE Always unplug your Cuisinart® Food Processor from the electrical outlet and remove the Cuisinart® continuous feed attachment from the food processor housing base before cleaning. Keep the discs out of the reach of children. • The work bowl, stem, and slinger disc are dishwasher safe but on the top rack only. Due to intense water heat, washing the work bowl, stem, and slinger disc on the bottom rack may cause damage over time. Insert the work bowl upside down for drainage. Remember to unload the dishwasher carefully when removing sharp discs. • To simplify cleaning, rinse the work bowl, stem adapter, slinger disc, and slicing/shredding discs immediately after use so food won't dry on them. If food lodges in the chute on the work bowl, remove it by running water through it, or use a bottle brush. • If you wash the discs by hand, do it carefully. When handling, use the plastic hubs. Avoid leaving them in soapy water where they may disappear from sight. If necessary, use a brush. • Work bowl should not be placed in a microwave oven. Any other servicing should be performed by an authorized service representative. OPERATING AND SAFETY TIPS Make sure the electrical outlet is rated at the same voltage as that stated on the bottom of the housing base. • Always use the continuous feed attachment with the Food Processor housing base on a clean, sturdy, and dry surface. • D on't put hands inside the continuous feed attachment work bowl or feed tube at any time. • Don't remove continuous feed attachment while unit is running. • Handle and store metal discs carefully, utilizing the storage hub provided with the food processor. Their cutting edges are very sharp. 4