Cuisinart DLC-2011CHBY Owner Manual - Page 16

temperature higher than 100˚F (37˚C). Doing so will slow or even prevent the action of the yeast. Kneading bread dough: Do not try to use the machine to knead dough that is too stiff to knead comfortably by hand. Doing so can strain the machine. After the dough starts to clean the inside of the work bowl completely and forms a ball, process it for 60 seconds to knead it. Stop the machine and test the dough to be sure it is properly kneaded. Typical bread dough should have a soft, pliable texture and it should feel slightly sticky. Stretch the dough with your hands to test it. If it feels hard, lumpy or uneven, continue processing until it feels uniformly soft and pliable. Make sure that the blade is firmly pressed back into place after removing the dough to test it. Kneading sweet dough: Shaping, finishing and baking: If you shape the dough in loaf pans, fill pans only half full. Let rise until dough is just slightly above the top of the pan. If shaping free-form loaves, let them rise on an oiled baking sheet until at least doubled in bulk. Making consecutive batches: You can make several batches of bread dough in a row. The motor in the Premier Series 11-Cup Food Processor is extremely efficient. TYPICAL BREAD DOUGH PROBLEMS AND SOLUTIONS If metal blade doesn't incorporate ingredients: Process dough for at least 30 seconds after all the ingredients have been incorporated. It may not clean the inside of the work bowl. If necessary, scrape the bowl and process for 5 more seconds. Rising: Put the dough in a large, lightly floured resealable plastic bag. Squeeze out all the air and close tightly, allowing space for the dough to rise. Or put the ball of dough in a large bowl coated with soft butter or vegetable oil. Roll the dough around to coat its entire surface. Cover it with a damp towel or a piece of oiled plastic wrap. Let it rise in a warm, draft-free place, about 80˚F (26˚C). The rising time is usually about 11/2 hours, but will vary from 45 minutes to several hours, depending on the type of flour and the humidity in the air. Always start processor before adding liquid. Add liquid in a slow, steady stream, only as fast as dry ingredients absorb it. If you hear liquid sloshing, stop adding it, but do not turn off machine. Instead, wait until ingredients in work bowl have mixed, then add remaining liquid slowly. Pour liquid onto dough as it passes under feed tube; do not pour liquid directly onto bottom of work bowl. Blade rises in work bowl: Blade may not have been pushed down as far as possible before processing started. Excessively sticky dough can cause blade to rise even though it cleans inside of work bowl. If dough feels very sticky, carefully reinsert blade and immediately add 2 tablespoons (30ml) flour through small feed tube while machine is running. Dough doesn't clean inside of work bowl: To test whether the dough has risen enough, stick a finger in it. An indentation should remain. If it doesn't, let the dough rise more and test again. • Amount of dough may exceed maximum capacity of your food processor. Remove half and process in 2 batches. When it has risen enough, punch the dough down. • Dough may be too dry. If it feels crumbly, add water, 1 tablespoon (15ml) at a time, while machine is running, until dough becomes moist 15