Cuisinart SG-3P1 User Manual - Page 5

CHARGING INSTRUCTIONS To charge your Cuisinart® Salt, Pepper and Spice Mill for use: 1. Follow assembly instructions for the Cuisinart® Salt, Pepper and Spice Mill and charging base on page 4 to properly assemble for charging. 2. Grasp assembled unit fig.10 securely and make sure it is facing upright. The Salt, Pepper and Spice Mill is facing upright when the Cuisinart® logo on the front of the unit is in proper reading orientation (easy to read and horizontal.) See fig.10. 3. Place the fully assembled Salt, Pepper and Spice Mill in the charging base so that the recessed area on the back of the unit housing fits comfortably with the protrusion on the charging base. See fig.11. fig.11 4. Plug charging base fig. into a 120v power 12 outlet. Your unit is now charging for use. NOTE: Unit is properly charging if red LED illuminates from charging base. See fig.12. OPERATION INSTRUCTIONS 1. Place housing and all removable parts on a clean, flat surface. Make sure that all parts have been cleaned and dried thoroughly and properly assembled before use. 2. Attach grinding container(s) to the unit housing with sea salt, peppercorns, or desired dried spice. NOTE: It is best to attach the grinding container from the bottom while holding the unit upright. 3. Line up the arrow on the grinding container with the arrow on the unit housing. NOTE: Both arrows should face each other. This will indicate the grinding container and unit are properly aligned. 4. Gently push the grinding container and unit housing together. The grinding container will fit together comfortably with the unit housing. 5. Twist the grinding container clockwise so that the arrow on the unit housing is now aligned with the lock symbol on the grinding container. NOTE: The two pieces will click together indicating proper assembly. 6. To attach the second grinding container, flip the unit housing over and repeat operating instructions. 7. Press the On/Off button in the center of the unit housing to begin grinding. NOTE: Only the bottom container will yield any grinding results. Even though the grinding container facing upward will rotate, no grinding will actually take place. For use with measuring cap: To use the measuring cap on either grinding container, grasp the measuring cap and connect to grinding container by aligning the grooves on the measuring cap with the ridges in the grinding container. Press together until the ridge of the measuring cap rests flat against the grinding container. NOTE: The measuring cap can be used on either container during operation only. When not in use, the measuring cap should remain in the uppermost grinding container as the unit housing will not fit into the charging base if the measuring cap is on the lower container. ADJUSTING THE GRIND To adjust the grind from fine to coarse, use the adjustment dial on the underside of the mill. Clockwise for a finer grind and counterclockwise for a coarser grind. 5