D-Link DCS-8000LH Quick Install Guide - Page 2

Minimum Requirements To install this product, you will need: • 802.11g/n wireless router • Internet connection • A mobile device with Bluetooth 4.0 is required for setup. • The latest version of the mydlink app from your operating system's application store. • The mydlink app is available for iPhone, iPad and Android™ devices. Please refer to the mobile app's store page to check whether your device is compatible. • An e-mail account (required to register for mydlink service) ? Frequently Asked Questions 1. What is a mydlink account? To use your mydlink device, you will need to register and sign in to a mydlink account. Once logged in, you can access your mydlink devices from anywhere via the Internet and enable features such as cloud recording for cameras. 2. What can I do if my camera is not working properly? First, reset the camera and try setting the camera up again. To make sure your hardware is installed correctly, make sure that: • the power LED is green • your Internet connection is working • your router's wireless is turned on • your router supports UPnP® • both your mobile device and camera have a working Internet connection If your camera is still not working, check your router and make sure it has the latest firmware. 3. What can I do if I forget my camera password? If you forget your password, you will need to reset your camera. This process will change all your settings back to the factory defaults. To reset your camera, please use an unfolded paperclip to press and hold the Reset button for at least 10 seconds while your camera is plugged in. Repeat the setup procedure through the app after the camera reboots and the front LED is blinking orange. 4. Why is there a white haze when viewing in night vision mode? When viewing in night vision mode, the IR lights on your camera may be reflecting off a nearby surface. Try repositioning your camera to avoid glare from IR LEDs. Mounting instructions 1. Place the camera base where you want to position the 1 camera and use a pencil to mark the holes. Make sure they are aligned and be careful not to move the base when marking the second hole. 2. Depending on the material of the wall or ceiling, use proper tools to drill two holes 1 inch deep with a 6mm 2 drill bit where you marked. If the wall is made out of concrete, drill the holes first, then insert the plastic anchors to support the screws. 3. Place the baseplate over the holes that are in the wall. 3 Make sure to align the baseplate holes with the holes in the wall. Use the supplied screws to attach the baseplate to the surface of the wall. 4. Place the camera into the mount. Make sure that the 4 power port in the back is exposed to the hole in the mount. Plug the USB power cable into the camera. Make sure it is plugged in all the way. 5. Align the slash marking on the base to the same slash 5 marking on the camera base. Press camera mount onto the base. 6. Twist the camera mount slightly clockwise to the right to lock it into place. Using a coin or flathead screwdriver, 6 tighten the screw on the left side of the camera mount to lock the camera angle into place. Support Need help setting up? Watch the video for step-by-step instructions: dlinksetup.com For manuals and software updates, visit: support.dlink.com For technical support, call: 1-877-453-5465 Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Version 3.00 (US)_90x130 6CS8000LQD05G June 22, 2018 Copyright ©2018 All rights reserved. D-Link and the D-Link logo are registered trademarks of D-Link Corporation or its subsidiaries. Product specifications, size and shape are subject to change without notice, and actual product appearance may differ from that depicted on the packaging. Visit dlink.com for more details. Mini HD Wi-Fi Camera Quick Start Guide DCS-8000LH