D-Link DES-802 User Guide - Page 22
Connecting Power, Network Connections
UPC - 790069211331
View all D-Link DES-802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connecting Power Power is supplied to the 10/100 Fast Ethernet Switch through an AC power cord. The AC power input voltage ranges from 100 to 240 VAC. A power cable is included with the device. Figure 6 : Connecting Power Since the 10/100 Fast Ethernet Switch does not include a power switch, plugging it in to a power outlet will immediately power it on. Network Connections If either port on the 10/100 Fast Ethernet Switch is set for full-duplex operation, the device (or LAN) connected to that port should also be set for full-duplex operation. The following sections discuss the requirements for each operating mode. 12 Installation
12
Installation
Connecting Power
Power is supplied to the 10/100 Fast Ethernet Switch through an AC power
cord.
The AC power input voltage ranges from 100 to 240 VAC.
A power
cable is included with the device.
Figure 6 : Connecting Power
Since the 10/100 Fast Ethernet Switch does not include a power switch,
plugging it in to a power outlet will immediately power it on.
Network Connections
If either port on the 10/100 Fast Ethernet Switch is set for full-duplex
operation, the device (or LAN) connected to that port should also be set for
full-duplex operation. The following sections discuss the requirements for
each operating mode.