D-Link DGS-1510-28X User Manual - Page 192
ACL Configuration Wizard Add Rule for IPv4 ACL PIM window
View all D-Link DGS-1510-28X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide 5 (critical), 6 (internet), and 7 (network). ToS After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max- throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. DSCP Select or enter the DSCP value used here. This value must be between 0 and 63. Time Range Enter the name of the time range to associate with this ACL rule. Action Select the action that this rule will take here. Options to choose from are Permit and Deny. After selecting the PIM option as the Protocol Type, the following section will appear. Figure 8-14 ACL Configuration Wizard (Add Rule for IPv4 ACL) PIM window The dynamic fields that can be configured are described below: Parameter Fragments Source Destination Description Select the Fragments option to include packet fragment filtering. Select and enter the source information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any source traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the source host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any destination traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the destination host's IP 184