D-Link DGS-1510-52XMP Hardver Install Guide - Page 21
Power Failure (AC Power), Installing Power Cord Clip, With the rough side facing down
View all D-Link DGS-1510-52XMP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide Power Failure (AC Power) In the event of a power failure, just as a precaution, unplug the power cord from the Switch. After the power returns, plug the power cord back into the power socket of the Switch. Installing Power Cord Clip To prevent accidental removal of the AC power cord, it is recommended to install the power cord clip together with the power cord. NOTE: The DGS-1510-52XMP does not support the installation of the power cord clip. With the rough side facing down, insert the Tie Wrap into the hole below the power socket. Figure 2-5 Insert Tie Wrap to the Switch Plug the AC power cord into the power socket of the Switch. Figure 2-6 Connect the power cord to the Switch 21