D-Link DGS-3420-28PC Hardware Installation Guide - Page 35
System Information, window, config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy - dgs 28sc manual
![]() |
View all D-Link DGS-3420-28PC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
xStack® DGS-3420 Series Layer 2+ Managed Stackable Gigabit Switch Hardware Installation Reference Guide DGS-3420-28SC:admin# show switch Command: show switch Device Type : DGS-3420-28SC Gigabit Ethernet Switch Unit ID : 1 MAC Address : 00-01-02-03-04-00 IP Address : 192.168.69.123 (Manual) VLAN Name : default Subnet Mask : 255.255.255.0 Default Gateway : 0.0.0.0 Boot PROM Version : Build 1.00.003 Firmware Version : Build 1.00.017 Hardware Version : A1 System Name : System Location : System Uptime : 0 days, 7 hours, 6 minutes, 50 seconds System Contact : Spanning Tree : Disabled GVRP : Disabled IGMP Snooping : Disabled MLD Snooping : Disabled RIP : Disabled RIPng : Disabled VLAN Trunk : Disabled Telnet : Enabled (TCP 23) CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All Figure 4-4 Show switch command The Switch's MAC address can also be found from the Web management program on the System Information window in the Configuration folder. The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known. The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows: Starting at the command line prompt, enter the commands config ipif System ipaddress xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy Where the x's represent the IP address to be assigned to the IP interface named System and the y's represent the corresponding subnet mask. Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's represent the IP address to be assigned to the IP interface named System and the z represents the corresponding number of subnets in CIDR notation. The IP interface named System on the Switch can be assigned an IP address and subnet mask, and then be used to connect a management station to the Switch's Telnet or Web-based management agent. DGS-3420-28SC:admin# config ipif System ipaddress 10.90.90.91/255.0.0.0 Command: config ipif System ipaddress 10.90.90.91/8 Success. DGS-3420-28SC:admin# 35
![](/manual_guide/products/dlink-dgs342028pc-hardware-installation-guide-b05de95/35.png)