D-Link DGS-3630-52TC User Manual - Page 180
Group Table, L2 Interface Group Entry Type
![]() |
View all D-Link DGS-3630-52TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Restrictions: This Policy ACL Flow Table is organized into two mutually exclusive logical sub-tables. One is used to match IPv6 flows and the other one is used to match non-IPv6 flows. These two tables should be considered as a single table. But there are some restrictions: • IPv6 packets might match two rules in the Policy ACL Flow table. It is recommended add ETH_TYPE or other Match Fields in the non-IPv6 logical table to avoid this issue. • The same meter cannot be applied to two rules in different sub-tables. It is recommended to apply different meters for different rules to avoid this issue. Group Table L2 Interface Group Entry Type Field Group Identifier Group Type Counters Action Buckets Description A 32-bit unsigned integer, uniquely identifying the group on the OpenFlow switch. The naming rule is shown in the L2 Interface Group Entry Naming Conversion table. Indirect. Specifies per-group entry counters. Supports a single action bucket. L2 Interface Group Entry Naming Conversion Field Interface ID Chain ID Bits 0 to 15 16 to 27 Kind 28 to 31 Description The interface ID. The ID that other group type entries chain to. The range is from 1 to 4094. 0 (L2 Interface). L2 Interface Group Entry Bucket Actions Field Output Description Supported on physical ports only. L2 Interface Group Entry Counters Field Reference Count (Flow Entries) Duration (Seconds) Description The number of flow entries or group entries that are currently referencing this group entry. The time, in seconds, since this group entry was installed. 173
![](/manual_guide/products/dlink-dgs3630-user-manual-7703634/180.png)