D-Link DI-624M Product Manual - Page 15

DI-624M User's Manual Super G without Turbo:: Super G with Static Turbo:: Super G with DynamicTurbo:: 802.11g Only Mode: SSID Broadcast: Security: Authentication: WEP Encryption: Key Type: Keys 1-4: Using the Configuration Menu Capable of Packet Bursting, FastFrames, Compression, and no Turbo mode. Capable of Packet Bursting, FastFrames, Compression, and Dynamic Turbo. This setting is backwards compatible with nonTurbo (legacy) devices. Dynamic Turbo mode is only enabled when all nodes on the wireless network is Super G with Dynamic Turbo enabled. Capable of Packet Bursting, FastFrames, Compression, and Static Turbo. This setting is not backwards compatible with nonTurbo (legacy) devices. Static turbo mode is always on and is only enabled when all nodes on the wireless network is Super G with Static Turbo enabled. Select this mode to restrict your network to only those devices that employ the 802.11g standard. Enabling this mode will ensure that you maintain the highest connectivity rate, unhampered by any connection to an 802.11b device. Choose Enabled to broadcast the SSID across the network. All devices on a network must share the same SSID (Service Set Identifier) to establish communication. Choose Disabled if you do not wish to broadcast the SSID over the network. Select None, WEP, WPA, or WPA-PSK encryption. Select Open System or Shared Key authentication. Wired Equivalent Privacy (WEP) is a wireless security protocol for Wireless Local Area Networks (WLAN). WEP provides security by encrypting the data that is sent over the WLAN. Select Enabled or Disabled. Disabled is the default setting. (Note: If you enable encryption on the DI-624M make sure to also enable encryption on all the wireless clients or wireless connection will not be established.) Select the level of encryption desired: 64-bit, or 128-bit. Select HEX or ASCII. Input up to 4 WEP keys; select the one you wish to use. D-Link Systems, Inc. 15