D-Link DI-704GU Quick Installation Guide - Page 5

Hardware Installation Hardware Installation A. First, connect the power adapter to the receptor at the back panel of the DI-704GU and then plug the other end of the power adapter to a wall outlet or power strip. The Power LED will turn ON to indicate proper operation. B. 1. Power off your Cable or DSL modem; some devices may not have a on/off switch and will require you to unplug the power adapter. Now, the DI-704GU should be powered on and the Cable/DSL modem should be turned off. 2. Cable/DSL modem (Power Off) - DI-704GU (Power On) Connect an Ethernet cable to the Ethernet jack located on the Cable/DSL modem. After the Ethernet cable is securely connected, power on the Cable/DSL modem by turning on the unit or plugging in the power adapter. 3. Cable/DSL modem (Power On) - DI-704GU (Power On) Insert the other end of the Ethernet cable to the WAN PORT on the back panel of the DI-704GU. The WAN LED light will illuminate to indicate proper connection. If the WAN LED is not illuminated, please go back to step B1 and repeat the instructions. C. Insert an Ethernet cable to LAN port 1 on the back panel of the DI-704GU and an available Ethernet port on the network adapter in the computer you will use to configure the DI-704GU. The LED light for LAN Port 1 will illuminate to indicate proper connection. Note: The LAN Ports on the DI-704GU are Auto-MDI/MDIX.Which means you can use straight-through or crossover Ethernet cables to connect to the LAN Ports. D. Computers equipped with Ethernet or Gigabit Ethernet adapters will be able to connect to the DI-704GU. The DFE-530TX or DGE530T PCI Adapters (as examples) will be able to connect with the router without any additional configuration required.  D-Link DI-704GU Quick Install Guide