D-Link DNH-100 Quick Install Guide - Page 5

ENGLISH Interface Connectors Configuration 12 3 4 5 Figure 2: Front Connectors # Connector Description Used for rebooting or resetting 1 Reset the device back to factory default settings. 2 Console RJ-45 port to connect the RJ-45 Port console cable for CLI management. 3 Ethernet Gigabit RJ-45 por t for LAN Port connection. 4 MicroSD MicroSD slot for MicroSD card2,3 Slot up to 32 Gb. USB 3.0 Type A port2 (provides 5 USB Port 5V/1A power for optional HDD connection). Table 2: Interface Description Installation The DNH-100 can be powered using the following methods: Using the Power Adapter 1. Connect the power connector of the adapter to the power input on the DNH-100 and plug the adapter into a nearby power outlet. Using Nuclias Connect The DNH-100 comes preloaded with Nuclias Connect. For detailed instructions on the use of Nuclias Connect please refer to the Nuclias Connect Manual. Manual Configuration Note: D-Link recommends manually configuring the device before mounting it. The management computer, DHCP server and DNH-100 must be in the same subnet. Use one of the following methods to access the web user interface: Connecting through Ethernet You need the following equipment to access the Web UI of your device: • A PC with a RJ-45 Ethernet connection • A standard Ethernet cable 1. Use an Ethernet cable to connect the DNH-100 to the management computer or to the switch or router the management computer is connected. 2. Manage the device from a computer. Enter https://192.168.0.200 in the address field of your browser. 3. Log in to the administration user interface. The default login information is Username: admin Password: admin DNH-100 Quick Installation Guide 3