D-Link DNH-100 Quick Install Guide - Page 6

ENGLISH Connecting through a Console Connection Use a console cable4 to connect to the switch's console port. This cable is a RS-232 serial to RJ45 connector cable designed to use with this switch. A terminal emulation program is required to connect to the console port on the switch. 1. Connect the RS-232 serial interface to the serial port of the management PC. 2. Connect the RJ-45 interface to the console port of the switch. 3. Open a terminal emulation program on the management PC and configure the properties of the connection as follows: • The speed (baud): 115200 bps • The data bits: 8 • The parity: None • The stop bits: 1 • The flow control should be None. 4. Connect to the switch and the Limited Command Line Interface (CLI) should be available. Mounting Mounting on a Solid Wall or Ceiling The DNH-100 can be mounted in an EIA standard size 19-inch rack, which can be placed in wiring closet with other equipment. 1. Attach the L-shaped mounting brackets to each side of the chassis as shown in Figure 3 and secure them with the screws provided. 2. Mount the device in the rack using a screwdriver and the supplied rackmounting screws. Figure 4: Installing in the Rack Connecting Power The AC power cord shipped with the device connects the device to earth ground when plugged into a grounded AC power outlet. The device must be grounded during normal operation. To connect the device to a power source, plug one end of the AC power cord into the AC power connector on the back panel of the device. Plug the other end into an AC power source. Figure 3: Attaching the Rack Mount Brackets 4 1 Due to EU regulations the 16 Gb MicroSD card is only included in the WW version. 2 Only FAT32 format is supported. 3 Do not remove the microSD card while the power is on as this may damage your card. 3 A D-Link console cable is recommended for best performance. DNH-100 Quick Installation Guide