D-Link DSN-3200-20 Quick Installation Guide - Page 11
Installing the DSN-3200 - power supply
UPC - 790069299742
View all D-Link DSN-3200-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installing the DSN-3200 1 Insert an Ethernet crossover cable into the management port of the DSN-3000 series and connect the other end to your management system's open Ethernet port (the one set to IP address 192.168.1.2). Note: The management port of the DSN-series does not support MDI and will require a crossover cable. Or if you wish, two standard straightthrough cables may be used with an intermediate switch or hub. The management port is 100MbE. 2 Insert an Ethernet cable into Host Network Connection #0 of the DSN-3000 series as identified on page 6 and the other end to a 1GbE port of your SAN network. 3 Insert each of the three power cables into the power supply as shown below. Then plug the other end of these power cables into a reliable filtered power source such as a UPS (Uninterruptible Power Supply). Proceed to Software Installation Overview for the DSN-3000 series. D-Link DSN-3200/3400 Installation Guide 11