D-Link DSN-3200-20 Quick Installation Guide - Page 12
Installing the DSN-3400 - support
UPC - 790069299742
View all D-Link DSN-3200-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing the DSN-3400 1 Insert an Ethernet crossover cable into the management port of the DSN-3000 series and connect the other end to your management system's open Ethernet port (the one set to IP address 192.168.1.2). Note: The management port of the DSN-3000 series does not support MDI and will require a crossover cable. Or if you wish, two standard straight-through cables may be used with an intermediate switch or hub. The management port is 100MbE. 2 Insert an Ethernet cable into the 10GbE Host Network Connection of the DSN-3000 series as identified on page 7 and the other end to the 10GbE port of your SAN network. 3 Insert each of the three power cables into the power supply as shown below. And then plug the other end of these power cables into a reliable filtered power source such as a UPS (Uninterruptible Power Supply). Proceed to Software Installation Overview for the DSN-3000 series. 12 D-Link DSN-3200/3400 Installation Guide