D-Link DWS-3227P Product Manual - Page 39
Advanced Configuration, Retrieving an IP Address From a DHCP Server
UPC - 790069289989
View all D-Link DWS-3227P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
DXS/DWS 3200 Series User Guide console# configure console(config)# snmp-server community priate rw 10.1.1.1 view bobi console(config)# exit console# show snmp Community-String Community-Access View name IP address priate read write bobi 10.1.1.1 private read write bobi 10.1.1.2 Community-String Group name IP address Type Traps are enabled. Authentication-failure trap is enabled. Version 1,2 notifications Target Address Type Community Version Udp Filter To Retries Port name Sec ------ Version 3 notifications Target Address Type Username Security Udp Filter To Retries Level Port name Sec ---- System Contact: System Location: This completes the initial configuration of the device from a local terminal. The configured parameters enable further device configuration from any remote location. Advanced Configuration This section provides information about dynamic allocation of IP addresses and security management based on the authentication, authorization, and accounting (AAA) mechanism, and includes the following topics: • Configuring IP Addresses through DHCP • Configuring IP Addresses through BOOTP • Security Management and Password Configuration When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received from these servers includes the IP address, and may include subnet mask and default gateway. Retrieving an IP Address From a DHCP Server When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. To retrieve an IP address from a DHCP server, perform the following steps: 1. Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in order to retrieve the IP address. 2. Enter the following commands to use the selected port for receiving the IP address. In the following example, the commands are based on the port type used for configuration. - Assigning Dynamic IP Addresses: console# configure console(config)# interface ethernet 1 console(config-if)# ip address dhcp hostname Page 38