DELPHI SA10221 User Guide - Page 11

Power Up the System

Get DELPHI SA10221 - XM Portable Satellite Radio Boombox PDF manuals and user guides
UPC - 689604164891
View all DELPHI SA10221 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Getting Started Power Up the System Use the power button on the receiver or on its remote control to turn on the receiver. If the display reads "ANTENNA" after powering up, check that the antenna connection is secure and completely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet). NOTE: Some receivers will power up automatically when installed in the Delphi Premium Sound System. If the "ANTENNA" message remains, power down the radio, unplug the antenna and look for any obvious damage in the connector, jack or antenna cable. If no damage is detected, reconnect the antenna, turn the unit back on, and change channels again. If the message still appears, contact your retailer. If the display reads "NO SIGNAL" after powering up, follow the instructions in "Setting up the Antenna" on page 5. 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
7
Getting Started
Power Up the System
Use the power button on the receiver or on its remote control to turn on
the receiver. If the display reads “ANTENNA” after powering up, check that
the antenna connection is secure and completely pushed in. Next, change
channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet).
NOTE: Some receivers will power up automatically when installed in the
Delphi Premium Sound System.
If the “ANTENNA” message remains, power down the radio, unplug
the antenna and look for any obvious damage in the connector, jack or
antenna cable. If no damage is detected, reconnect the antenna, turn the
unit back on, and change channels again. If the message still appears,
contact your retailer.
If the display reads “NO SIGNAL” after powering up, follow the instructions
in “Setting up the Antenna” on page 5.