Dacor DCT305 Installation Instructions - Page 10
Installing the Burner Components
View all Dacor DCT305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation Instructions Installing the Burner Components warning • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. 1. Remove the burner rings, burner caps and grates from their shipping packages. 2. Assemble the burners as shown. Match the burner parts to the correct size and type of burner. When installing the burner components, make sure they are centered. Twist each piece back and forth slightly until it drops completely into place. The burners will not operate properly unless all of the burner pieces are properly seated. On model DCT305, the left rear burner cap has tabs on the bottom that fit into the slots on the top of the burner ring. Inner burner cap (bottom shown) Outer burner cap Burner ring Line up indentations on bottom of burner ring with pins on top of base. Burner base SimmerSear™ Burner Assembly (center of cooktop) Burner cap (bottom shown) Burner ring Fit hole in burner ring over igniter Burner cap (bottom shown) Burner ring Fit hole in burner ring over igniter Burner base Igniter CAUTION: Top of igniter is sharp Standard Burner Assembly Burner base Igniter CAUTION: Top of igniter is sharp Left Rear Standard Burner Assembly - DCT305 8