Dacor DHD48MW Use and Care Manual - Page 20

Care and maintenance Care and maintenance Replacing the light bulbs WARNING • The owner changes the bulb. Before replacing a bulb (or if a light does not work), verify that power is ON at the circuit breaker, fuse box, light swich, or main power switch. • To prevent electric shock, turn power OFF at the fuse box or circuit breaker panel, then replace the light bulb. • To avoid risk of fire, use bulbs no stronger than 7.5W LED or 75W, 120V Halogen. • To avoid a burn injury, ensure the hood and the bulb lens are cool before changing the bulb. • To avoid system damage and faulty performance, use only dimmable bulbs. Fixture Dimmable Bulb 1. (To avoid harming the appliance electrical system should a short occur) Turn power OFF at the circuit breaker or fuse box. 2. Wipe the bulb lens clean, then gently press the suction-cup tool onto the lens. 3. Turn the tool left to loosen the bulb, then remove the bulb from the housing. 4. Attach the suction-cup tool to the lens of the replacement bulb. 5. Insert the bulb into the housing, and turn the tool handle right to tighten the bulb. 6. Remove the suction cup, and turn the power ON at the fuse box or circuit panel. Suction Cup NOTE • If buying your own bulb, take the old bulb to the store as reference, or use these specifications: Dimmable LED 7.5W (max) or Halogen 75W (max), 120V; PAR16, E26/27, 500 lumens. • If the bulb does not engage, ensure the new bulb's lens is clean, then repeat Steps 4 and 5, being sure to insert the bulb fully into the housing. 20 English