Dacor DR30EI Planning Guides - Page 1

DR30ES, DR30EFS, DR30EIS, DR30EIFS Document # PG05-008 Distinctive™ 30" Wide Electric Ranges Revised 10/30/12 Page 1/4 PLANNING GUIDE Product Dimensions All tolerances ±1/16" (±1.6 mm) unless otherwise noted. warning • Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • This appliance must be installed in accordance with the accompanying installation instructions. A B C D 1" (2.5 cm) Front of open door Front of handle/knobs Front panel Rear of front panel Backguard thickness External handle shown, some models have integral handle (see inside cover) Product width: 29 15/16" (76.0 cm) 9" (22.9 cm) Backguard* 6" (15.2 cm) 3" (7.6 cm) backguard* backguard* DR30EI[F]S: 3/8" (9.5 mm) DR30E[F]S: Full stainless steel side panels DR30EI[F]S: 3" (7.6 cm) partial stainless steel side panels (removable) 35" (88.9 cm) to 37" (94.0 cm) *See table for compatibility Dimension DR30ES DR30EIS A 46 1/8" (117.2 cm) B 27 3/4" (70.5 cm) C 25 3/8" (64.5 cm) D 23 1/4" (64.1 cm) DR30EFS DR30EIFS 46" (116.8 cm) 27 5/8" (70.2 cm) 25 1/4" (64.1 cm) 23 1/8" (58.7 cm) Overall Depth Dimensions - side view Part Number ADRB30E03 Description 3 Inch Compatibility Optional on all models ADRB30E06 6 Inch Standard on models DR30ES, DR30EFS Optional on models DR30EIS, DR30EIFS ADRB30E09 9 Inch Optional on all models Models DR30EIS and DR30EIFS come equipped from the factory with flat stainless trim piece in place of a backguard. A backguard may be purchased as an optional accessory. The trim on models DR30ES and DR30EFS are not compatible with a raised vent. Models DR30EIS and DR30EIFS are compatible with Dacor raised vent models ERV3015. Use only theses specified raised vent models. Available Backguards All specifications subject to change without notice. www.dacor.com Phone: (800) 793-0093