Dacor ECS230SCH Installation Instructions - Page 4

Dacor Model Number ECS127 MCS127 ECS130 PCS130 MCS130 ECS136 MCS227 MCS227 ECD227 MCD227 ECS230 PCS230 MCS230 ECD230 PCD230 MCD230 Overall Width "E .... 27" (686mm) 30" (762mm) 36" (914mm) Overall Height F .... Chassis Depth G .... 28 3/8" (721mm) 28 5/8" (727mm) 27" (686mm) 23 7/8" 30" (762mm) 49 15/16" (1270mm) Overall Dimensions 1" (25mm) Cooktop Regulator Recess "H" (25ram) 4 Single Wall Oven Overall Dimensions (Epicure Shown) EPICURE TM MILLENNIA TM PREFERENCE TM Side View Handle Projections Recess Width H .... 5_ (!27mm) 6 1/4" (!59mm) 6 3/8" (!62mm) 5 _, (!27mm) 6 1/4" (!59mm) Recess Height J .... Recess Depth K" 5 1/4" (133mm) 8" (203mm) Installing the Support Platform in the Cabinet Provide a platform within the cabinet upon which the oven will be supported. The platform must be installed level and straight. The top edge d the platform must be flush with the cutout at the front of the cabinet. There are no provisions to level the oven after it has been installed. 3/4" (19mm) thick plywood is recommended. NOTE: An oven that is not level may provide poor or inconsistent baking results. Electrical Power Supply Requirements It is the owner's responsibility to ensure that a qualified electrician performs the electrical connection of this appliance. The electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSIINFPA 70-1990" (or to the latest revision) and local codes and ordinances. *A copy of this standard may be obtained from: NationaI Fire Protection Association 1 Batterymarch Park Quincy, Massachusetts 02269-9101 "G" Recess The correct voltage, frequency, and amperage must be supplied to the appliance from a "H" separate, grounded, single phase circuit that is protected by a properly sized circuit breaker or time-delay fuse. If a time-delay fuse is utilized, fuse both sides of the line (L1 and L2). "E" Double Wall Oven Overall Dimensions (Epicure Shown) The required voltage, frequency and amperage ratings are listed on the product data plate (located inside the intake grill to the right of the door latch) and in the Table on page 4. 5/8" [_ WARNING: If the electrical service provided does not meet the product specifications, do not proceed with the installation. Call a licensed electrician to correct. NOTES: 1. Preheat times and cavity temperature recovery times will be increased slightly if operating on a 120/208 volt power supply. , 208V models should not be con nected to 240V source power. , Power supply must be an isolated circuit. 3 =::_=lcar: