Dacor ECS230SCH Use and Care Guide - Page 15

• Soakthefilterinhotsoapwy ater. • Drythefiltercompleteblyeforere-installing • Tore-instathllefiltero, rientthetwomountintagbstowards therearo, penenddownH. ookthetwomountintagbsover thecentehr orizontbaal r. 2. Remove the broiler pan and grill, all cookware, utensils and other loose items from the oven chamber. Also, remove all oven racks and the convection fan filter to prevent them from permanently discoloring. However, to clean stubborn particles in the convection filter you may elect to simply leave it in place during self-clean. The filter wilt discolor due to the high heat, but the filtering capabilities will not be affected. 3. Wipe up excess grease and other food spills with a damp cloth. This wilt minimize smoke and increase the efficiency of the self-clean cycle. 4. Turn on kitchen fans or vents to help remove odors during the process. IMPORTANT: If racks are left in the oven during a self-clean cycle, it will affect their ability to slide in and out easily. If damage occurs, polish the rack edges with a soapy steel wool pad, then apply a small amount of vegetable oil to the edges so that the racks will slide more easily. Convection Filter Installation To Start the Self-Clean Cycle: 1. Close the oven door completely. Self Cleaning 2. Press the SELF-CLEAN key. The oven wilt beep once, "CLEAN" will flash, and " : " will be displayed. 3. Press the TIME • TEMP + key and the default time of "2:00" hours will be displayed. 4. Increase the self-clean time up to 4 hours (depending upon the amount of oven soil) by holding the TIME • TEMP + key. The oven features an automatic pyrolytic self-cleaning cycle to eliminate the need for difficult and time-consuming manual scrubbing of interior surfaces. During this cycle, the oven reaches temperatures of 850°F to burn off soil and deposits. A powder ash residue is left in the bottom of the oven after completion of the self-clean cycle. The self-clean time is variable from 2 to 4 hours to offer flexibility in handling various soil conditions. A 2-hour cycle normally handles a moderately soiled oven, whereas a 4-hour cycle is recommended for heavy soil. The self-clean cycle can also be delayed to start at a later time if desired. IMPORTANT: • It is normal for some smoke to be emitted during the first few self-clean cycles. • Popping sounds are normal during self-clean. These sounds are caused by the expansion and contraction of metal surfaces during heat-up and cool-down. • Do not line the oven with aluminum foil or other materials. These items can melt or burn during a self-clean cycle, causing permanent damage to the oven. To Prepare the Oven for Self-Cleaning: 1. Clean soil from the oven front frame area and the oven door outside of the door gasket. Do not clean the door gasket. Cleaning the door gasket by hand can cause it to bend or move. A tight door seal is essential for proper baking and self-cleaning Rinse surfaces welt with a solution of vinegar and water, then wipe dry. Heavily soiled areas may be cleaned with a non-scratching scouring pad. 5. To delay the self-clean start to a more convenient time, press the STOP TIME key. Then, press the TIME • TEMP + key to set the time of day for the cycle to be complete. "DELAY TIMED" will appear in the clock display. The cycle can be delayed up to 11 hours and 50 minutes. 6. Approximately 30 to 60 seconds after selecting self-clean, the automatic door latch wilt lock the door. "LOCK" and "ON" wilt appear in the clock display. The oven wilt begin heating. The "ON" indicator will cycle on and off with the burner. NOTE: If delay timed mode has been set, the "ON" display and the oven heat will not turn on until the programmed time has been reached. IMPORTANT: The electric door latch is a convenient CLEAN LOCK ON HR .UU CLEAN TIME safety feature that keeps the door locked when T,OIEI °CI LOIICSK,OPIIT,MOEEI°2 the interior is too hot. If the door is not closed Display - Self-Cleaning Mode completely, the automatic door latch wilt not lock the door when the self-clean is selected. In this case, "Door" will flash in the display, Press the CANCEL • SECURE key and wait about 1 minute. Repeat the self-clean steps from the beginning, being certain to close the door completely. Do not try to force the door open after it is locked, because damage can occur. If you need to unlock the door, press the CANCEL • SECURE key to turn off the self-clean cycle. After about 1 minute, "LOCK" will disappear from the clock display, and the door will unlock. The door will remain locked until the oven temperature falls below 390°F. Continued... 13