Dacor EH3012 Installation Instructions - Page 11
Preparing for Installation, Installation Instructions
View all Dacor EH3012 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Preparing for Installation Back wall Ceiling or cabinet bottom Duct Cut-Out for Rear Venting Duct Cut-Out for Top Venting Installation Instructions warning • Do not install the range hood unless the electrical service provided meets the range hood specifications. • Observe all governing codes and ordinances during installation. Contact your local building department for further information. • A qualified technician must complete the installation of this built-in appliance. More than one person is required to raise the hood into place. The owner is responsible to make sure the hood is properly installed. 1. Start by removing the filters from the bottom of the hood. Put them in a safe location so that they will not be damaged. 2. If the hood will be installed in a top exhaust configuration, skip to page 16. If the hood will be installed so that air will exhaust out of the back, the blowers must be rotated into the correct position before hanging the hood. The procedure for rotating the blower depends on the hood model number. See the table at the right. Blower Rotation Instructions MODEL EH3012, MH3012, EH3612, MH3612, EH4212 EH4812, MH4812 EH3018, MH3018, EH3618, MH3618, EH4218 EH4818, MH4818, EH5418 SEE PAGE 10 11 13 15 9