Dacor EORS127 Installation Instructions - Page 11

Installation Instructions Removing the Oven Door on Model EORS136: 1. Open the door to its fully opened position. 2. Rotate the catch over the retaining arm on each hinge. Catch 3. Lift the oven door to about a 15° angle from the vertical position. 4. Hold the door with both hands just below the handle and pull it away from the oven while continuing to lift. Gripping point Retaining arm Steps 1 and 2 Gripping point Steps 3 and 4 Electrical Connection warning • If the electrical service provided does not meet the Product Specifications (see page 4), do not proceed with the installation. Call a licensed electrician to correctly install the required wiring. • Failure to disconnect power prior to installation may result in an electrical shock or fire hazard. • Do not turn on power to the appliance until the oven is properly grounded according to these instructions. • The installer must connect the ground terminal (or lead) on the appliance to a grounded, metallic, permanent wiring system or grounding conductor. Failure to do so may result in an electric shock hazard. • Do not use an extension cord with this appliance. Such use may result in fire, electric shock or personal injury. • Do not install a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit may result in an electric shock hazard. • The appliance must be connected to the power supply with copper wire only. The use of aluminum wire may result in unsatisfactory conditions. IMPORTANT Provide slack in the conduit to allow the oven to slide forward for servicing. note The electrical connection leads from the supplied appliance conduit may be a smaller gage than the standard household wiring of the dedicated supply circuit. They are suitable for connection to household wiring under the jurisdiction of the National Electric Code, and/or the local inspection authority. 1. Before proceeding, turn off power to the circuit to which the oven will be connected at the circuit breaker or fuse box. 2. Position the oven directly in front of the cabinet cut out. 3. Feed the appliance conduit into the electrical junction box and attach it using a UL approved strain relief. 4. Depending upon local codes, utilize one of three methods to connect the appliance to the electrical power: ◊ Connect to a four wire electrical system ◊ Connect to a three wire electrical system, where local codes permit ◊ Connect to a three wire electrical system with external ground, according to local codes. See the instructions on the following pages for detailed directions. 9