Dacor MCS130 User Manual - Classic Wall Oven - Page 18
Before You Call For Service
View all Dacor MCS130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Before You Call For Service Problem Solution Guide Unnecessary service calls may be expensive, frustrating and time-consuming. Before you call for service, please review the potential problems, possible causes and remedies shown below. Also, see the facing page for various oven failure codes that can be displayed on the control panel. Failure codes will appear where the temperature is normally displayed on the control panel. PROBLEM Nothing works. Oven will not heat. Clock displays incorrect time of day. Foods over-cook. POSSIBLE CAUSE POSSIBLE SOLUTION Oven is not connected to electrical power. Have oven connected to a properly sized electrical power supply by a qualified electrician. Power supply is not energized. Check for tripped circuit breaker or blown fuse. Have an electrician check power supply. Oven settings are not correct. Follow mode selection and clock settings as specified in OVEN OPERATION section. Oven is set for delay-timed cooking. Oven will turn on automatically at time set. If desired, press CANCEL • SECURE key to cancel out of delay timed cooking. Time of day is not set. Press CLOCK touch pad, then press TIME • TEMP + or TIME • TEMP - key to set correct time of day. Power supply has been interrupted. Reset time of day. Incorrect cooking time, temperature or rack Adjust temperature or time settings. position being used. Foods under-cook. Oven does not self-clean. Oven light will not work. Door will not open. Oven temperature calibration differs from your previous oven. Calibrate temperature according to Adjusting the Oven Temperature section (see Care and Cleaning). Incorrect cooking time, temperature or rack Adjust temperature or time settings. position being used. Oven temperature calibration differs from your previous oven. Calibrate temperature according to Adjusting the Oven Temperature section (see Care and Cleaning). Door is not shut tight so automatic door latch will not lock. Close door tightly. Oven settings are not correct. Follow mode selection and clock settings as specified in the Self-Cleaning section (see Care and Cleaning). Oven is set for delay timed cleaning. Oven will turn on automatically at time set. If desired, press CANCEL • SECURE key to cancel out delay-timed cleaning. Light bulb is burned out. Follow Replacing the Oven Light section (see Care and Cleaning). Oven is in self-clean mode. If oven is hot, door latch will release automatically when oven temperature falls below 390˚F at end of cycle. If SELF-CLEAN was just selected and the oven is still cool, press CANCEL • SECURE key to turn off self-clean. The door will open in about 30 seconds. Oven is set to self-clean in delay-timed mode. Oven will turn on automatically at time set. If desired, press CANCEL • SECURE key to cancel out of delay-timed mode. 16