Dacor MH3618 Installation Instructions - Page 21

Installation Instructions Final Electrical Installation warning • To avoid electric shock or fire hazard, prior to connecting the electrical wiring to the hood, make sure that power to the hood power supply line is turned off at the fuse box or circuit breaker panel. • Improper connection of the hood electrical wiring may create an electric shock or fire hazard and may result in damage to the hood's electrical system. See page 6 for specifications. • Do not ground the hood to the neutral (white) power supply wire. Connect the hood ground wire to a separate, properly grounded wire installed by a licensed electrician. • Make sure all wire used is capable of handling the total connected load. See page 3. 1. Turn off power to the hood electrical circuit at the circuit breaker or fuse box. 2. Feed the wiring through the wiring access holes in the hood. Connect the wiring to the terminal block inside the hood as shown. 3. Connect the hood wiring to an electrical junction box on a dedicated circuit. See page 6 for specifications. Connect it according to the wiring diagram below or on the following page. To house circuit breaker panel or fuse box Junction box Wire nut, 3 places GREEN GREEN WHITE WHITE BLACK BLACK Neutral (white) Ground (green) Hot (black) To junction box Not used N1 Gnd L1 Hood power terminals UL/CSA approved NEMA strain relief To range hood 3 Wire Connection to Junction Box 19