Dacor RV30 Use & Care Manuals - Page 6
Care and Cleaning - filter
View all Dacor RV30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Care and Cleaning warning • Clean the vent only in the manner specified. • To avoid dangerous fumes or damage to your vent's surfaces, use only the types of cleaning solutions specified in this manual. • To avoid personal injury, turn off the range and vent and make sure all surrounding surfaces are cool before cleaning. • Always wipe stainless steel (silver colored) surfaces with the grain. To prevent scratching, do not use abrasive cleaners or scrubbers on stainless steel surfaces. • To avoid damage to the fan, do not reinstall damaged filters. • To avoid damage, do not clean the filters in a dishwasher. Grill Cleaning Cleaning the Filters • Secure the keypad (see facing page). • Remove the grill with the vent in the raised position. Gently grasp the grill on both ends. Lift it up, then rotate the bottom of the grill out of the lower groove. Clean it regularly. Hand wash it in hot water with a mild detergent solution. Set the grill on a flat surface and wipe only in the direction of the grill grain. • Do not use any cleaners containing ammonia as this will damage the anodized aluminum finish. A soft toothbrush or nylon bristle dish brush may be used to clean the grill grooves. Slide bottom out Lift here Lift here Clean the filters and surrounding areas regularly to prevent grease build-up. The CLEAN FILTER key indicator light will illuminate after 40 hours of blower use to remind you to clean the filters (push the CLEAN FILTER key to reset). The filters may need to be cleaned more often based upon the type and amount of cooking. Check the filters regularly. To clean the filters: CLEAN FILTER • Raise the vent to the "up" position to clean the filters. • Remove the grill as described in the Grill Cleaning section. • The filters are positioned side by side inside the vent intake. When properly installed, the tops of the filters lean against the rear intake panel and the filter bottoms rest in a slot attached to the front intake panel. Remove one filter at a time by gently grasping the top center of the filter and lifting it up and out. Removing the Grill • After cleaning, reinstall the grill. Align the left and right edges of the grill with the vertical grill guides and insert the upper edge of the grill into the slot in the top cap. Pivot and drop the bottom of the grill into the lower locating slot. Vertical grill guide (left shown) Top cap Rear intake panel Grasp filter and lift Front intake panel Raised vent side view Grill mount groove Location of Mounting Groove • Clean the filters by hand washing them in hot water with a mild detergent solution. Clean the intake panel also (see following page). • Make sure the filters are dry before carefully reinstalling them. • Reinstall the intake grill. 4