Dacor RV30 Use & Care Manuals - Page 7
Before You Call for Service, Care and Cleaning - clean filter light won t turn off
View all Dacor RV30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Care and Cleaning Cleaning the Intake Panel Cleaning the Top Cap The intake panels accumulate grease over time and should be cleaned whenever the filters are washed. • After removing the grill and filters, wipe all external and internal aluminum surfaces with a sponge or cloth moistened with a mild detergent. Rinse off with water. Remove all moisture by wiping with a soft, dry polishing cloth. Always wipe in the direction of the grain. Do not use any abrasive substances on the intake panels, as this may permanently mar the finish. • Dry and reinstall all components prior to operating the vent system. Clean the top cap only when the intake vent is in the lowered position. The top cap and end caps may have painted finishes (depending on the model) that will scratch or stain if cleaned with abrasive materials or harsh chemicals. • Gently wipe them with a sponge or soft cloth moistened in a mild detergent solution whenever they becomes soiled. Avoid introduction of moisture into the electronic keypad area. Cleaning the Electronic Keypad Do not use any abrasive materials to clean the keypad. • The keypad and surrounding the plastic bezel should be gently wiped with a lightly dampened sponge or cloth. Any material that becomes lodged between the buttons and the surrounding bezel may be removed by carefully dabbing with a cotton swab or the edge of a cloth. Use the above method to prevent the buttons from sticking. • After cleaning, immediately dry the keypad area with a soft cloth. Before You Call for Service Problem Solution Guide problem Nothing works. Vent intake raises or lowers partially then stops. Gas flame is being pulled by draw of vent. Clean filter symbol is lit. may be caused by what to DO Raised vent not connected to elec- Turn on power at circuit breaker or fuse box. trical power. Check for tripped breaker or blown fuse. Power outage. Contact power company. Keypad is deactivated. Reactivate control panel: press HIGH and LOW keys at the same time. Hold down for one second. An obstruction is interfering with the vent intake movement. Immediately press UP/DOWN key, then disconnect the power plug. Remove the obstruction. Reconnect the vent power plug and press Up/Down key to raise or lower intake. Short duct run or high output of Reduce blower speed to a lower setting. system make ventilating force very strong. Blower has operated for over 40 hours. Inspect and clean filters. See Care and Cleaning section. 5