Danby DAC6011E Product Manual - Page 14

Operating Instructions USING THE REMOTE CONTROLLER BUTTONS TIMER OPERATION To set the Auto-start time. ON/OFF MODE 1) Push the TIMER button when the unit is operational, only the Auto-stop feature can be set. TEMP UP S TEMP DOWN 2) Keep pressing the TIMER button, each ENERGY SAVER 1 press will increase the selected time by FAN TIMER 1 hour increments, up to 12 hours. 3) The time can be set in a range of 0~12 hours. CLEAN AIR SLEEP 4) After the desired time has established, wait for about 10 seconds until the setting temperature reverts back in the display window of the air conditioner. This indicates the program is set. NOTE: To cancel the TIMER setting, push the TIMER button until 0 hour is displayed on the LCD window of the air conditioner. ON/OFF MODE TEMP UP FAN S TEMP DOWN ENERGY SAVER TIMER 1 CLEAN AIR SLEEP CLEAN AIR OPERATION When this button is pushed, the ion generator is energized and will help remove pollen and impurities from the air. Press it again to stop the operation. 1 ON/OFF MODE TEMP UP FAN S TEMP DOWN ENERGY SAVER TIMER CLEAN AIR SLEEP ENERGY SAVER OPERATION In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling stars. 13