Danby DAR154BLSST Product Manual - Page 6

OPERATING INSTRUCTIONS Please use the unit between 5-32°C(41°F-90°F) ambient temperature. If the ambient temperature is higher than lower than this temperature it will cause the temperature to fluctuate in the cabinet. CONTROL PANEL INSTRUCTIONS FUNCTIONS Temperature Memory Function • In the event of power loss the set temperature will be saved by the unit. Once the power is back on the unit will return the same set temperature. Door Ajar Alarm Function • If the door is not fully closed, there will be a warning alarm after 5 minutes. Indicator light illuminates to signify the cooling mode is currently in operation. Control the interior light ON/OFF. To turn on/off appliance (press and hold this button for approximately 3 seconds). Temperature Alarm Function • If inner temperature is higher than 73°F (23°C). The "HI" is shown in display panel and the alarm will sound. It informs you that the inner temperature is too high, please check the reason why. • If inner temperature is lower than 32°F (0°C), the "LO" is shown in display panel and the alarm will sound as well the malfunction indicator light will illuminate. Used to raise (warmer) the temperature by 1°C or 1°F increments. Used to lower (cooler) the temperature by 1°C or 1°F increments. (°C / °F) Adjacent indicator light denotes which scale of temperature is displayed. SETTING THE TEMPERATURE CONTROLS When you plug in your refrigerator for the first time the temperature will automatically be set to 41 °F (5°C) and will be displayed in the Fahrenheit scale (°F) • The temperature range can be set as low as 36 °F (2°C) or as high as 50°F (10°C) to suit your specific storage requirements. Each depression of the buttons will allow you adjust the temperature in 1° degree increments within the aforementioned range. SHELVES IMPORTANT! Do not cover the gap on the glass shelves with aluminum foil or any other material that will prevent adequate air circulation within the cabinet. When removing any of these shelves out of the rail compartment, you must first disassemble and remove the plastic posts then remove the Lock screws that hold each post in place.(Fig A) To re-install, ensure the shelf is resting securely on the support brackets and push shelf inward until it locks into place. Gap • To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the buttons simultaneously for approximately 3-5 seconds. Lock Plastic Screws Posts Fig A. 4