Danby DPAC12011 Product Manual - Page 11

TROUBLESHOOTING Occasionally, a problem may occur that is minor, and a service call may not be necessary. Use this tmubleshonting guide for a possible whit:inn. If the unit continues to nr in ;i properly, call an authorized service depot for assistance, or Danby's Toll Free Number 1400-26- PROBLEM 1) us dies not work POSSIBLE CAUSE SOLUTIONS • Power is out. • The pips is not plugged inpromidr.. et:he lulmank iwx`ii" is ON; tans is • • Wpluaigt fmorppipopwaedryt.o return. Remk ove Cram water from the drain • t leaking cr pressing test tutton on LC0I plug. • tao Press the reset button aflet resolving problem. • Indoor set temperature has been 2) Unit suddenly stops during operation. • 'cached. The reset time is up. • The hill•tank indenter is ON; tan.< is • Reset the temperature level. • Reset the timer. •• Rtaerm&ove Crain water from the drain 541. 3) Unit runs intermittently • Malfunction. • Contact your dealer. • Surrounding temp. is too high/low. • mis is normal. • Exhaust duct hose is blocked. • Check the duct hose. 4) Unit functions but the room is not cooled • Window or door is open in room. • There is a heat sauce or too many le in the roam. • Air intake grill is clogged. • Filter is too dirty; • Temperature scttiog is too high. • Close all windows/doors. • Move any heat sources from room. • Clean air intake grill. • Replace the filter. Lower term. setting. 5) Condensed water spills out when moving the unit. • The tank is nearly full. • Remove Crain plug on rear bottom and drain out water.