DeLonghi BCO90 Owner Manual - Page 7
How To Select The Aroma Of The Drip, Coffee, How To Prepare Espresso Coffee - heaters
View all DeLonghi BCO90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
• Open the filter holder by swinging it out to the left (fig. 6). • Place the permanent filter into the filter holder (fig. 7). • Put the ground coffee into the filter by using the measuring spoon included with the machine and level off the grounds uniformly (fig. 8). As a general rule, use one level measuring spoonful of coffee (about 7 grams) for each cup of coffee (for example, use 10 measures to make 10 cups of coffee). In any case, the quantity of ground coffee to use can vary according to the strength desired and personal taste. Use high quality ground coffee, with a medium grind and the kind packaged especially for drip coffee makers. • Close the filter holder and place the pot, with its lid inserted, onto the hot plate. • Select the aroma desired as indicated in the paragraph "How to select the aroma of the drip coffee". • Press the "ON/OFF" switch for drip coffee (fig. 9). The ON indicator light for drip coffee above the switch itself indicates that the coffee machine filter is functioning properly. • If more than five cups of coffee are desired, press the switch (with the symbol) (fig. 10) and the indicator light will light up. If, on the other hand, five or fewer cups of coffee are desired, the switch should not be pressed. In this way, the hot water will flow more slowly through the ground coffee and a more flavourful beverage will be obtained. • The brewed coffee will begin to drip out after a few seconds. It is completely normal that during the percolation of the coffee, some steam may escape from the machine. • If you keep "ON/OFF" switch for drip coffee on the ON position after the percolation, the warming plate will maintain the hot coffee at an ideal drinking temperature. HOW TO SELECT THE AROMA OF THE DRIP COFFEE With the ACCUFLAVOR , it is possible to select the aroma of the drip coffee depending on personal taste. By turning the aroma regulation knob of the coffee filter (fig. 11), the coffee machine can be programmed for a strong flavour (STRONG position) or a lighter flavour (LIGHT position). The ACCUFLAVOR feature changes the flavourof the coffee, more or less strong, while the taste of the coffee remains unchanged. HOW TO PREPARE ESPRESSO COFFEE 1. Unscrew the boiler cap by turning it in a counter-clockwise direction. 2. Using the level indications stamped on the WATER LEVEL side, fill the small pot with the amount of water suggested (fig. 12) according to the number of cups of espresso coffee that are desired (see the chart at the end of this text). 3. Pour the water into the hot water heater tank (fig. 13). 4. Replace the boiler cap by turning firmly in a clockwise direction. 5. Insert the filter for espresso coffee into the filter holder (fig. 14). 6. Fill the filter with the ground coffee, respecting the dosages indicated in the chart at the end of this text and distribute it uniformly in the filter (fig. 15). It is important to use the highest quality coffee and having a medium grind in order to avoid the obstruction of the filter during the brewing. Remove any excess coffee from around the edges of the filter (fig. 16). 7. To attach the filter holder to the appliance, position it under the boiler outlet with the handle towards the left, see fig. 17. Push upwards, and at the same time, turn the handle towards the right. Always turn right to the end. 8. Place the coffee pot for espresso coffee under the filter holder so that the spout where the coffee exits is inside of the opening on the lid of the coffee pot (fig. 18). 9. Position the "Vario System" selector according the type of espresso coffee desired: "LIGHT" for a lighter coffee and "STRONG" for a stronger tasting brew (fig. 19). 10. Make sure that the steam release knob is closed. 11. Push the ON/OFF switch for espresso/cappuccino. The ON indicator light for espresso/cappuccino will turn on (fig. 20). 7