DeLonghi PAC A130HPE Owner Manual - Page 3

Semi-permanent installation SEMI-PERMANENT INSTALLATION If required, your appliance can also be installed semi-permanently (Fig. E). • Fit the wall flange 11 into the hole. • Fit the air exhaust hose 12 into the air exhaust hose housing 8 located on the rear side of the appliance (fig. A page 5). • Fit the end of the hose 12 to the wall flange 11 as shown in fig. G. 11,8 in 30 cm 11,8 in 30 cm E Proceed as follows: • Drill a hole ø 5,25 inches (ø 134 mm) in an outside wall or through a window pane. Respect the dimensions and height of the hole given in figure F and G. G MAX100 cm MAX 39,37 inches MIN 35 cm MIN 13,77 inches When the hose 12 is not connected, the drilled hole can be closed with the flange cap 11 . NOTE: When installing the air conditioner semi-permanently, you should leave a door slightly open as little as 1/2 " (1 cm) to guarantee correct ventilation and room pressure. 134 5,27 in. in the window pane F in the wooden kickboard of a French window in the wall: it is recommended that you insulate a section of the wall using suitable insulation. Keep the exhaust hose as short and free of curves as possible to avoid constrictions. "As special tools are required for installation, we suggest you have the appliance installed by specialized personnel." 6