DeLonghi PAC160 Owner Manual - Page 12

pac160 GB 25-01-2003 10:19 Pagina 12 Operation Once the dehumidifying function has been selected, the fan speed cannot be changed. The appliance will automatically select the correct fan mode. VENTILATION Adjust the fan speed by pressing the "FAN" (Q) button, as illustrated in the air conditioning function. Bear in mind that the higher the speed, the greater the volume of air filtered; by selecting the "Silent" speed, less air is filtered, but the noise level is low. "AUTO" function cannot be selected in this mode. The display will show the fan speed selected. PROGRAMMING THE TIMER The timer programs the appliance to switch on and switch off. This will save electrical energy by optimizing the operating times. The timer is set using the buttons + (F) or - (G); these increase and decrease by one hour at a time, but if pressed for more than 2 seconds will automatically change the time more quickly, up to a maximum of 24 hours. How to set the delayed start function • Connect the appliance to the mains supply and press ON/OFF button: next, select the required operating mode (temperature, fan speed etc.) • Press the ON/OFF button again: the appliance will go into stand-by mode. • Press the timer button (I): on the display the two central segments will start to flash. • Set the number of hours after which the appliance should switch on, by pressing the + or - buttons. The indicator (L) on the display will continue to flash until the appliance starts operating. The appliance can be programmed for up to 24 hours in advance. How to set the delayed stop function • The appliance can be programmed for delayed stop from any of the operating modes (air-conditioning/dehumidifying/ventilation. • Press the Timer button (I): on the display the two central segments will start to flash. • Set the number of hours after which the appliance should switch off by pressing the + or - buttons. The indicator (L) on the display will continue to flash until the appliance switches itself off. It will then go into Stand-by mode. . "Silent" speed "Min" speed "Max" speed 24 12