Dell 2009WFP User's Guide - Page 24
Solving Problems
View all Dell 2009WFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Back to Contents Page Solving Problems Dell™ 2009W Flat Panel Monitor User's Guide Troubleshooting Your Monitor Common Problems Product Specific Problems Universal Serial Bus Specific Problems Dell™ Soundbar Troubleshooting CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions. Troubleshooting Your Monitor Self-Test Feature Check Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing the following steps: 1. Turn off both your computer and the monitor. 2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both the Digital (white connector) and the Analog (blue connector) cables from the back of computer. 3. Turn on the monitor. The floating dialog box should appear on-screen (against a black background), if the monitor cannot sense a video signal and is working correctly. While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll through the screen. or or 4. This box also appears during normal system operation if the video cable becomes disconnected or damaged. 5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning properly. Common Problems The following table contains general information about common monitor problems you might encounter and the possible solutions. Common Symptoms What You Experience No Video/ Power LED off No picture Possible Solutions l Ensure that the video cable connecting the monitor and the computer is properly connected and secure. l Verify that the power outlet is functioning properly by using any other electrical equipment. l Ensure that the power button is depressed fully. No Video/ Power LED on No picture or no brightness l Increase brightness & contrast controls via OSD. l Perform monitor self-test feature check. l Check for bent or broken pins in the video cable connector. Poor Focus Picture is fuzzy, blurry, or ghosting l Perform Auto Adjust via OSD. l Adjust the Phase and Pixel Clock controls via OSD. l Eliminate video extension cables. l Reset the monitor to Factory Settings. l Change the video resolution to the correct aspect ration (16:10). Shaky/Jittery Video Wavy picture or fine movement l Perform Auto Adjust via OSD. l Adjust the Phase and Pixel Clock controls via OSD. l Reset the monitor to Factory Settings. l Check environmental factors. l Relocate the monitor and test in another room.