Dell 341-1626 Owners Manual - Page 85
Replacing The Internal USB Key
View all Dell 341-1626 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Replacing The Internal USB Key CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2. If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface. NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface. 3. Open the system. 4. Locate the USB connector (INT USB) or the USB key on the system board. 5. If applicable, remove the USB key. 6. Insert the new USB key into the USB connector. 7. Close the system. 8. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward. 9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. 10. Enter the System Setup and verify that the USB key is detected by the system. Figure 41. Replacing the Internal USB Key 1. USB key 85