Dell Alienware Aurora R7 Aurora R6/R7 U.2 Solid-State Drive Installation Guide - Page 6
Installing the U.2 solid-state drive
View all Dell Alienware Aurora R7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2 Installing the U.2 solid-state drive NOTE: Ensure that you remove the security cable and security screw from the security-cable slot-if applicable. 1 Remove the screw (#6-32 X 1/2") that secures the side-panel release latch to the chassis. 2 Pull the side-panel release latch. 3 Release the left-side cover away from the chassis and then lift it from the computer. Figure 1. Removing the left-side cover 1 screw 2 side-panel release latch 3 top cover 4 left-side cover 4 Lay the computer on the right side. 5 Disconnect the data and power cables from the hard drive. 6 Press the release tabs on the hard-drive carrier and slide the hard-drive carrier out of the hard-drive cage. 6 Installing the U.2 solid-state drive
Installing the U.2 solid-state drive
NOTE:
Ensure that you remove the security cable and security screw from the security-cable slot—if applicable.
1
Remove the screw (#6-32 X 1/2") that secures the side-panel release latch to the chassis.
2
Pull the side-panel release latch.
3
Release the left-side cover away from the chassis and then lift it from the computer.
Figure 1. Removing the left-side cover
1
screw
2
side-panel release latch
3
top cover
4
left-side cover
4
Lay the computer on the right side.
5
Disconnect the data and power cables from the hard drive.
6
Press the release tabs on the hard-drive carrier and slide the hard-drive carrier out of the hard-drive cage.
2
6
Installing the U.2 solid-state drive