Dell Brocade 300 Fabric Watch Administrator's Guide v7.1.0 - Page 83
TABLE 17, E_Port class default settings Continued
View all Dell Brocade 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
portThConfig command procedures 7 TABLE 17 Area E_Port class default settings (Continued) Description Default threshold settings Default alarm settings Threshold state Signal loss Monitors the number of signal loss errors. Unit: Errors Time Base: minute Low: 0 High: 5 Buffer: 0 Below: 0 Above: 0 Sync loss Monitors the number of loss of synchronization errors. Unit: Errors Time Base: minute Low: 0 High: 500 Buffer: 50 Below: 0 Above: 0 Packet loss (VE_Port only) The number of packets routed through a port exceeds the port bandwidth. Unit: Errors Time Base: minute Low: 0 High: 100 Buffer: 0 Below: 0 Above: 0 Protocol errors (PE) Monitors the number of primitive sequence errors. Unit: Errors Time Base: minute Low: 0 High: 5 Buffer: 0 Below: 0 Above: 0 Received packets (RXP) Monitors the receive rate, by percentage. Unit: Percentage (%) Time Base: minute Low: 0 High: 100 Buffer: 0 Below: 0 Above: 0 State changes (ST) Monitors state changes. Unit: Changes Time Base: minute Low: 0 High: 50 Buffer: 0 Below: 0 Above: 0 Transmitted packets Monitors the (TXP) transmit rate, by percentage. Unit: Percentage (%) Time Base: minute Low: 0 High: 100 Buffer: 0 Below: 0 Above: 0 Trunk utilization The percent of utilization for the trunk at the time of the last poll. Unit: Percentage (%) Time Base: minute Low: 0 High: 100 Buffer: 0 Below: 0 Above: 0 Informative Out_of_range Informative Out_of_range Informative Informative Informative Out_of_range Informative Informative Informative Out_of_range Informative Informative Informative Informative Fabric Watch Administrator's Guide 63 53-1002752-01