Dell Brocade 5100 Brocade 7.3.0 Fabric OS Command Reference - Page 1148

2 switchShow Fabric ID oversubscribed One fabric has been assigned two different fabric IDs (EX_Ports only). AoQ Application-oriented QoS; indicates that an F_Port or N_Port has negotiated a link that is capable of quality of service (QoS). Both sides of the link have QoS capability and agreed on the protocol. The link could be between an HBA and an Access Gateway, between an Access Gateway and an edge switch, or between an HBA and an edge switch. LB mode If the Access Gateway cannot negotiate QoS capabilities with the edge switch, an HBA connected to the Access Gateway will not be able to negotiate a QoS link with the Access Gateway. (logical) Indicates a logical port. The switchShow output shows all logical ports currently present in the logical switch. The command displays -1 for the slot for logical ports and the user port number for slot port. The logical port numbers are not persistent and may change when the logical interswitch links (LISLs) are deleted and recreated. A logical port is shown to be in one of the following states: E_Port (if the port is online), offline, or disabled. When the port is disabled, a reason is provided. segmented Indicates a segmented or disabled port along with one of the following segmentation reasons: (Encrypt incompatible) Port segmentation or port disable due to mismatched configurations. (Compress incompatible) Port segmentation or port disable due to mismatched configurations. (Encrypt limitation) Port segmentation or port disable due to reaching encryption limitations. (Compress limitation) Port segmentation or port disable due to reaching compression limitations. (Authentication failure) Port segmentation or port disable due to authentication failure. (Defzone conflict) Port segmentation due to defzone states. (Type mismatch) D_Port configuration mismatch between local and remote switch. When used with the -slot option, the command displays the following blade-specific information: slot Slot number. Blade Type Type of blade, for example, Core blade or AP blade. Refer to the slotShow command for a listing of supported blade types. ID A numeric blade ID that specifies the blade type. Refer to the slotShow command for a listing of supported blade IDs. Status Enabled or disabled. 1118 Fabric OS Command Reference 53-1003131-01