Dell Brocade 6510 Brocade Fabric OS v7.0.1 Release Notes v1.0 - Page 30

WWN in lower case characters, the merge will fail, since the switches do not recognize these zoning configurations as being the same. For additional details and workaround solutions, please refer to the latest FOS Admin Guide updates or contact Brocade Customer Support. Miscellaneous Using a Windows anonymous FTP server for supportsave collection When using anonymous ftp, to avoid long delays or failure of simultaneous supportsave collections when AP blades are present in a director chassis, the number of unlimited anonymous users for a Windows FTP server should be configured as follows: Number of anonymous FTP connections = (Number of director chassis) + (Number of installed Application Blades x 3) RASlog message AN-1010 may be seen occasionally indicating ―Severe latency bottleneck detected‖. Even though it is a ―Warning‖ message, it is likely to be a false alarm and can be ignored. POST diagnostics for the Brocade 5100 have been modified beginning with FOS v6.3.1b and v6.4.0 to eliminate an ―INIT NOT DONE‖ error at the end of an ASIC diagnostic port loopback test. This modification addresses BL-1020 Initialization errors encountered during the POST portloopbacktest. (Defect 263200) It is important to note that the outputs of slotshow -p and chassishow commands also display the maximum allowed power consumption per slot. These are absolute maximum values and should not be confused with the real-time power consumption on 16G blades. The chassisshow command has a ―Power Usage (Watts):‖ field that shows the actual power consumed in real-time on 16G blades. Class 3 frames that have been trapped to CPU will be discarded in the following scenarios on DCX/DCX-4S/DCX8510 during the following conditions: HA failover on DCX/DCX-4S/DCX8510 platforms while running FOS v7.0 or later firmware Firmware upgrade from v7.0 to a later release on Brocade 300, 5100, VA-40FC, 5300, 6510 Firmware upgrade from v7.0.1 to a later release on Brocade 6505 The QSFP information in the sfpshow output will indicate the ID field as all zeros. This is as designed. ras080:FID128:root> sfpshow 5/32 QSFP No: 8 Channel No:0 Identifier: 13 QSFP+ Connector: 12 MPO Parallel Optic Transceiver: 0000000000000000 16_Gbps id It is recommended that for directors with more than 300 E_Ports, the switch be disabled prior to executing the ―switchCfgTrunk‖ command (used to disable or enable trunking on the switch). During non-disruptive firmware upgrades, E_Ports in R-RDY mode may cause some frame drops on the E-port links. For the configure command, in FOS v6.4, or later the default value that displays for Maximum Logins per switch is different than the value that displays in FOS v6.3.x. The default value has not changed; it was displayed incorrectly in FOS v6.3.x, and is now corrected. Fabric OS v7.0.1 Release Notes v1.0 Page 30 of 67