Dell C1660W Dell Users Guide - Page 43
Verifying the IP Settings, The Operator Panel, The System Settings Report, The Ping Command - default password
View all Dell C1660W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Verifying the IP Settings You can confirm the settings by using the operator panel, printing the printer settings report, or using the ping command. NOTE: A Password is required to enter Admin Menu when Panel Lock Set is set to Enable. In this case, enter the password you specified, and press the (Set) button. The Operator Panel 1 Press the (Menu) button. 2 Press the button until Admin Menu appears, and then press the (set) button. 3 Ensure that Network appears, and then press the (set) button. 4 Press the button until TCP/IP appears, and then press the (set) button. 5 Press the button until IPv4 appears, and then press the (set) button. Check the IP address displayed on the operator panel. The System Settings Report 1 Print the system settings report. For details about how to print a system settings report, see "Printing a Report/List Using the Operator Panel" on page 125. 2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under Wired Network or Wireless Network. If the IP address shows 0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your printer, see "Assigning an IP Address" on page 39. The Ping Command Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping followed by the new IP address (for example, 192.168.0.11): ping 192.168.0.11 If the printer is active on the network, you will receive a reply. Setting the IP Address 41