Dell Force10 S25-01-GE-24V Quick Start Guide for the S25 System - Page 19

Step Task 3 Set your initial console terminal settings to match the default console settings on the switch. 9600 baud rate No parity 8 data bits 1 stop bit No flow control (console port only) After establishing a connection, you can modify the settings to match at each end of the connection. 4 S25P only: If you use the console port to download software to the switch, you will probably want to raise the console baud rate. Establish a connection with the default settings to verify the connection. Then use the lineconfig command to access the Line Config mode, and use the serial baudrate command to raise the baud rate on the console port. (Match the settings in your terminal access program.) Accessing the Console Port Connect the RJ-45/DB-9 adapter that is shipped with the S25P system to the RJ45 cable. Table 2-1. Pin Assignments for Console Port Signal NC NC RXD GND GND TXD NC NC RJ-45 Pinout 1 2 3 4 5 6 7 8 Installing the Software 17